The operation process of automatic warp - in machine. Warp - in operation includes equipment preparation, yarn preparation, yarn - in and weaving.

Equipment preparation: including the placement of the warp bar, the link of the heald frame, the placement of the reeds, the subsequent placement of the warp bar in the warp shed and the heald wire in the heald shed.

Cooperate with the yarn frame car to complete the yarn preparation link, the yarn is prepared to the yarn frame, hang a heavy hammer, hit the tension, finally use the steel comb to open the yarn layer in the yarn, use the tool to clamp the yarn layer, then the heavy hammer can be removed and start to hit the tension. While carding the yarn, raise the frame to the middle position.

Threading process: operate the threading process and pattern setting, equipment specification setting, boot parameter setting on the operating table. Then the modules are in place and the yarn can be worn.

Machine operation: After the browning operation is completed, the worn warp stop piece, heald frame and reed are removed from the equipment.